Apparatus provided in the kit Are ...

Below is the list of some of the apparatus provided.

1. Small portable box with revolving top for easy access to chemicals

and apparatus, replacing big racks.

2. Polyethylene dispensing bottles (squeeze type) to dispense liquid

chemicals drop wise avoiding contamination of chemicals.

3. Well plates for fast and easy precipitation.

4. W -tubes for fast gas absorption.

5. Aluminum block for safe determination of melting point and boiling

point.

6. Kerosene burner

7. Micro burettes.

8. Plastic droppers for easy transfer of liquids.

9. Miniature glasswares for least consumption of chemicals.

10. Micro filtration unit.

11. Micro spatulas

Description of Kit Items


Comments

Post a Comment

Popular posts from this blog

Young’s Modulus ‘Y’ By Searle’s Method

Image
Aim:  To determine Young’s modulus of elasticity of the material of a given wire by Searle’s method.  Procedure: i. Arrange the experimental set up as shown in diagram. Attach a zero load (slotted hanger it self) and dead load (E) to the frames of the experimental wire and dummy wire respectively so that the wires become free of kinks and remain vertically straight. ii. With the help of micrometer screw gauge, find the correct diameter of the wire at three different places. At every place two readings of the micrometer are taken while holding it in one position and another perpendicular to it by rotating through 90°. iii. In all, six readings of the diameter of the wire are taken. Hence mean diameter and radius of the wire is found out. iv. Adjust the spirit level so that the air bubble is at the centre. Note down the reading of the micrometer screw (M) attached to it. This is zero reading. (This contains main scale reading ...
Read more

Spectrometer I - Refractive index of the prism.

PROCEDURE: I. To determine the angle of the prism 1. The preliminary adjustments for telescope, prism and the collimator are done. 2. The slit is illuminated by a sodium vapour lamp. The prism table is mounted vertically. 3. The refracting edge of the prism placed facing the collimator. 4. The image on one side is seen through through the telescope and the vernier readings (R1) are noted. 5. The image on other side is seen through through the telescope and the vernier readings (R2) are noted. 6. 2A = R1  R2  hence the angle of the prism ‘A’ is determined using A =  II. To determine the angle of minimum deviation 1. The edge of the prism is placed facing away from the collimator. 2. The refracting image is obtained in the telescope. The prism table is slowly rotated. 3. The image moves, then stops and turns back. The position of the image where the image stops and turns back is the minimum deviation. 4. The vernier readings (R3) are noted at this position and the direct ray reading (...
Read more

Laboratory Safety Rules Need To Follow ( Part 2 )

22. If you or your lab partner is hurt, immediately (and loudly) yell out the teacher's name to get the teacher's attention.  Do not panic. 23. If a chemical should splash in your eye(s) or on your skin, immediately flush with running water for at least 20 minutes.  Immediately (and loudly) yell out the teacher's name to get the teacher's attention. 24. All chemicals in the laboratory are to be considered dangerous. Avoid handling chemicals with fingers. Always use a tweezer. When making an observation, keep at least 1 foot away from the specimen. Do not taste, or smell any chemicals. 25. Check the label on all chemical bottles twice before removing any of the contents.  Take only as much chemical as you need. 26. Never return unused chemicals to their original container. 27. Never remove chemicals or other materials from the laboratory area. 28. Never handle broken glass with your bare hands.  Use a brush and dustpan to clean up broken glass.  Place...
Read more